This machine is suitable for testing the normal temperature bending resistance of finished shoes and soles (sheets). Its principle is to install the finished shoes or soles on the bending test machine, to conduct bending tests at a certain angle and a certain frequency, to measure the cracks (openings) and the length of rubber opening of soles and fences after a certain number of bending times, and to observe the changes of upper.

Standard requirements for general test methods and flexural test methods for footwear GB/T3903.1-2008

Fixture: 4 sets

2. Bending angle: 0-55 [+1], adjustable

3. Test speed: (0-300+10) r/min adjustable

4. Counter: LCD0-999, 999 times can be set, with power-off memory function

5. Motor: variable frequency motor 2KW

6. Blasting device for sample: 1/station for casting pipeline

7. The fixture adopts special design:

Upper Fixture: Linear linear guide rail is adopted, which can be used to clamp special large and small size shoes.

Lower fixture: can change different locating holes, can adapt to different requirements of high and low shoe head clamping. Locking device adopts external rotating mode, which is convenient to make.

Use;

8. The transmission adopts mechanical eccentric bearing without adding lubricating oil. It has simple maintenance and low noise.

9. Weight: about 600 KG

10. Power supply: 1, AC220V, 8A

11. Volume: (150 x 87 x 140) cm

1, 35-42 size shoe last 4 pairs

A 2,5+0.05mm cutting knife

3,0.02mm precision digital vernier calipers.

4. A magnifying glass